maximum signal
英 [ˈmæksɪməm ˈsɪɡnəl]
美 [ˈmæksɪməm ˈsɪɡnəl]
【电】最大信号
双语例句
- To deliver the maximum signal voltage from driver to receiver, the differential impedance must be low at the driver and high at the receiver.
由驱动器向接收器提供最大的信号电压，驱动器的差分阻抗应当取低，而接收器中应当取高。 - Though the maximum output level ( S+ N) principle is often adopted in engineering, it was the maximum signal noise ratio ( SNR) principle that is used in the theoretical analysis.
对选择式合并，工程中常采用最大输出电平准则（S+N），但在理论分析中却都用最大信噪比准则（SNR）下的结果来代替。 - The Optimum Noise source Resistance and Maximum Signal power Transmission in Low Noise Pre Amplifier
低噪声前置放大器的最佳噪声源电阻与最大信号功率传输问题 - To make use of the maximum signal margin with the maximum scanning distance tolerance, the switching threshold should be set at the mid-way point between the background and mark signals.
在使用具有最大扫描距离偏差的最大信号边限时，转换门限应该设置在背景与标识信号的正中间？ - The basic principle to pickup the fault characteristics is introduced mainly about the relations between the maximum module and signal saltation point and how to characterize the saltation point with Lipschitz exponent.
探讨了用小波变换进行故障特征提取的原理，说明了小波变换模极大值和信号突变点之间的关系以及怎样用李氏指数来表征突变点的性质。 - The Maximum Signal Method for Improving Location Precision of DSRC Road Beacons and its Engineering Realization
提高DSRC道路信标定位精度的最大信号法及其工程实现 - The wavelet transform modular maximum of signal corresponds to the singularity of signal. Because the wavelet transform modular maximum of signal is contrary to one of noise on different scales, the noise can be eliminated from the signal.
信号小波变换模的局部极大值和信号奇异性之间存在对应关系，利用信号和噪声小波变换模极大值在不同尺度上表现出的截然不同的性质，可以对奇异信号进行消噪。 - Combined the characteristics of TD-SCDMA, the corresponding algorithms based on Maximum Signal to Noise Ratio criterion and Maximum Signal to Interference and Noise Ratio criterion are investigated thoroughly.
结合TD-SCDMA系统的特点，深入研究了最大信噪比（MSNR）准则和最大信干噪比（MSINR）准则的下行波束赋形算法。 - This paper proceeds an evaluation of selection diversity in Nakagami fading channel according to the principle of maximum output level. Closed form expression of bit error rate is derived and compared with the principle of maximum signal noise ratio.
本文根据最大输出电平准则，对选择式合并在Nakagami信道上的性能作了比以往理论分析更符合实际的评价，导出了误码率的闭式解，并与最大信噪比准则时作了比较。 - Modulation signals have peak value at zero frequency section, and the noise was no significant peak in the section, we can use this characteristic to distinguish the noise and modulation signal. By calculating the ratio of maximum and average signal to determine whether exist signals.
该算法根据调制信号在零频率的循环谱截面存在峰值，而噪声在该截面无明显峰值这一特点来区分噪声和信号，通过计算该截面的最大值与均值的比例来判断是否为信号。